From: Jean-Christophe PLAGNIOL-VILLARD Date: Fri, 8 May 2009 18:56:53 +0200 Subject: [U-Boot] [PATCH 2/6] ZOOM2 Add initial support for Zoom2 In-Reply-To: <1241731686-9844-2-git-send-email-Tom.Rix@windriver.com> References: <1241731686-9844-1-git-send-email-Tom.Rix@windriver.com> <1241731686-9844-2-git-send-email-Tom.Rix@windriver.com> Message-ID: <20090508165653.GB28481@game.jcrosoft.org> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 16:28 Thu 07 May , Tom Rix wrote: > Zoom2 is a new board from Texas Instruments and LogicPD > > The logicpd web site is a good source for general information on this board. > Please start looking here if the below links are broken. > http://www.logicpd.com > > This is a pdf of the product > http://www.logicpd.com/sites/default/files/1012659A_Zoom_OMAP34x-II_MDP_Brief.pdf > This is the product description web page > http://www.logicpd.com/products/development-kits/texas-instruments-zoom%E2%84%A2-omap34x-ii-mdp > > This patch provides a zoom2 base target by copying zoom1 and by making some > obvious changes. > > To configure, run > make omap3_zoom2_config > > Signed-off-by: Tom Rix > --- Applied to arm/next Best Regards, J.