From: Jean-Christophe PLAGNIOL-VILLARD Date: Sun, 17 May 2009 11:38:34 +0200 Subject: [U-Boot] [PATCH 1/2] ZOOM2 Add serial support. In-Reply-To: <1242499778-26465-1-git-send-email-Tom.Rix@windriver.com> References: <1242499778-26465-1-git-send-email-Tom.Rix@windriver.com> Message-ID: <20090517093834.GR16288@game.jcrosoft.org> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 13:49 Sat 16 May , Tom Rix wrote: > Zoom2 serial is in general supplied by one of the 4 UARTS on the debug board. > The default serial is from the USB connector on left side of the debug board. > The USB connector will produce 2 of the 4 UARTS. On your host pick the first > enumeration. > > The details of the setting of the serial gpmc setup are not available. > The values were provided by another party. > > The serial port set up is the same with Zoom1. > Baud rate 115200, 8 bit data, no parity, 1 stop bit, no flow. > > The kernel bootargs are > console=ttyS3,115200n8 > > Signed-off-by: Tom Rix > > ixx > Signed-off-by: Tom Rix ??? > --- Applied to arm/next Best Regards, J.