From: Simon Kagstrom Date: Wed, 1 Jul 2009 16:19:45 +0200 Subject: [U-Boot] OpenRD base/client support? In-Reply-To: <200907011603.25306.dk-arm-linux@gmx.de> References: <20090701155741.7e46e423@marrow.netinsight.se> <200907011603.25306.dk-arm-linux@gmx.de> Message-ID: <20090701161945.050d979a@marrow.netinsight.se> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Wed, 1 Jul 2009 16:03:25 +0200 Dieter Kiermaier wrote: > > It works "pretty well" with U-boot built for sheevaplug - my main > > problem now is that it hangs on miiphy_reset. > > I can confirm that. Have the same behaviour but haven't time to investigate further. > Maybe we can share information and coordinate some work? Sure. I've created a board support package for OpenRD base which is still basically a copy of sheevaplug. I can submit it if Prafulla wants to, but it's very preliminary still. The problem with the phy_reset was simple though: The phy simply has a different address than the one for sheevaplug. The patch below (against my board package - not possible to apply!) fixes this. // Simon diff --git a/include/configs/openrd_base.h b/include/configs/openrd_base.h index eb62554..996eacf 100644 --- a/include/configs/openrd_base.h +++ b/include/configs/openrd_base.h @@ -187,8 +187,8 @@ #define CONFIG_MII /* expose smi ove miiphy interface */ #define CONFIG_KIRKWOOD_EGIGA /* Enable kirkwood Gbe Controller Driver */ #define CONFIG_SYS_FAULT_ECHO_LINK_DOWN /* detect link using phy */ -#define CONFIG_KIRKWOOD_EGIGA_PORTS {1,0} /* enable port 0 only */ -#define CONFIG_PHY_BASE_ADR 0 +#define CONFIG_KIRKWOOD_EGIGA_PORTS {1,1} /* enable both ports */ +#define CONFIG_PHY_BASE_ADR 0x8 #define CONFIG_ENV_OVERWRITE /* ethaddr can be reprogrammed */ #define CONFIG_RESET_PHY_R /* use reset_phy() to init mv8831116 PHY */ #endif /* CONFIG_CMD_NET */