From: Wolfgang Denk Date: Tue, 22 Sep 2009 22:37:13 +0200 Subject: [U-Boot] [PATCHv5 2/2] mucmc52, uc101: delete ata@3a00 node, if no CF card is detected In-Reply-To: <4AAF1FE4.9050704@denx.de> References: <4AAF1FE4.9050704@denx.de> Message-ID: <20090922203713.D45DB832E864@gemini.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Dear Heiko Schocher, In message <4AAF1FE4.9050704@denx.de> you wrote: > U-Boot can detect if an IDE device is present or not. > If not, and this new config option is activated, U-Boot > removes the ATA node from the DTS before booting Linux, > so the Linux IDE driver does not probe the device and > crash. This is needed for buggy hardware (uc101) where > no pull down resistor is connected to the signal IDE5V_DD7. > > Signed-off-by: Heiko Schocher Seems this patch depends on other patches, that add support for the manroland boards, which have not been accepted yet. I think I'm waiting for a resubmit from you? Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de ATTENTION: Despite Any Other Listing of Product Contents Found Here- on, the Consumer is Advised That, in Actuality, This Product Consists Of 99.9999999999% Empty Space.