From: Wolfgang Denk Date: Fri, 23 Oct 2009 16:53:29 +0200 Subject: [U-Boot] [PATCH V2] ppc4xx: Initialize magnetic couplers in PLU405 In-Reply-To: <200910231638.11295.matthias.fuchs@esd.eu> References: <200910231638.11295.matthias.fuchs@esd.eu> Message-ID: <20091023145329.15A2CE398E1@gemini.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Dear Matthias Fuchs, In message <200910231638.11295.matthias.fuchs@esd.eu> you wrote: > This patch fixes an ugly behavior of the IL712 magnetic couplers > as used on PLU405. These parts will remember their last state > over a power cycle which might cause unwanted behavior. ... > --- a/board/esd/plu405/plu405.c > +++ b/board/esd/plu405/plu405.c > @@ -45,6 +45,55 @@ const unsigned char fpgadata[] = > */ > #include "../common/fpga.c" > > +/* > + * SJA1000 register layout in basic can mode > + */ > +struct sja1000_basic_s { > + u8 cr; > + u8 cmr; > + u8 sr; > + u8 ir; > + u8 ac; > + u8 am; > + u8 btr0; > + u8 btr1; > + u8 oc; > + u8 txb[10]; > + u8 rxb[10]; > + u8 unused; > + u8 cdr; > +}; > + > +#define SJA1000_CR_RR 0x01 > +#define SJA1000_OC_MODE0 0x01 Hmm... a SJA1000 is a pretty generic piece of hardware, and in no way specific to the plu405 board. Would it not make sense to create as separate header file for this? Eventually other boards will need to interface to SJA1000's, too ? Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de To be awake is to be alive. - Henry David Thoreau, in "Walden"