From: Wolfgang Denk Date: Sun, 15 Nov 2009 22:20:33 +0100 Subject: [U-Boot] [PATCH v4] OMAP3: add CM-T35 board In-Reply-To: <1258296430-19678-1-git-send-email-mike@compulab.co.il> References: <1258296430-19678-1-git-send-email-mike@compulab.co.il> Message-ID: <20091115212033.533D2E34A4B@gemini.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Dear Mike Rapoport, In message <1258296430-19678-1-git-send-email-mike@compulab.co.il> you wrote: > Add CM-T35 board support ... > MAINTAINERS | 4 + > MAKEALL | 1 + > Makefile | 2 + > board/cm-t35/Makefile | 47 +++++++ > board/cm-t35/cm-t35.c | 190 +++++++++++++++++++++++++++++ > board/cm-t35/cm-t35.h | 173 ++++++++++++++++++++++++++ > board/cm-t35/config.mk | 30 +++++ > doc/README.omap3 | 16 ++- > include/configs/cm-t35.h | 299 ++++++++++++++++++++++++++++++++++++++++++++++ > 9 files changed, 760 insertions(+), 2 deletions(-) > create mode 100644 board/cm-t35/Makefile > create mode 100644 board/cm-t35/cm-t35.c > create mode 100644 board/cm-t35/cm-t35.h > create mode 100644 board/cm-t35/config.mk > create mode 100644 include/configs/cm-t35.h Would it be possible to rename this into cm_t35? I would like to avoid characters in board names (and thus make targets etc. that are not legal in shell/Make/C variable names. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de "Everybody is talking about the weather but nobody does anything about it." - Mark Twain