From: giometti@enneenne.com (Rodolfo Giometti) Date: Tue, 17 Nov 2009 13:05:01 +0100 Subject: [PATCH] arm pxa: remove "direction input" forcing for IRQ GPIOs In-Reply-To: <20091117114429.GT14091@buzzloop.caiaq.de> References: <1258456906-12338-1-git-send-email-giometti@linux.it> <20091117114429.GT14091@buzzloop.caiaq.de> Message-ID: <20091117120501.GC8008@gundam.enneenne.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Tue, Nov 17, 2009 at 12:44:29PM +0100, Daniel Mack wrote: > On Tue, Nov 17, 2009 at 12:21:46PM +0100, Rodolfo Giometti wrote: > > PXA CPUs may use their GPIOs as IRQ lines even if they are selected as > > outputs (see for example figure 24-1 into PXA27x Processor Family > > Developer's Manual). So forcing GPIOs IRQ lines as inputs is not > > correct. > > > > Programmers should set up GPIOs direction according to their usage and > > the function pxa_gpio_irq_type() should simply enable the IRQ > > detection. > > Interesting. Is this an academic issue or do you actually use that? > That would mean you externally drive the IO pin level to something else > than the output driver provides, which isn't healthy at all. It's a real configuration with no electrical drawbacks at all! Of course the driver's output must be passive (I use it to detect a CARD insert) but it's functional. Ciao, Rodolfo -- GNU/Linux Solutions e-mail: giometti at enneenne.com Linux Device Driver giometti at linux.it Embedded Systems phone: +39 349 2432127 UNIX programming skype: rodolfo.giometti Freelance ICT Italia - Consulente ICT Italia - www.consulenti-ict.it