From: s.hauer@pengutronix.de (Sascha Hauer) Date: Mon, 21 Dec 2009 12:17:26 +0100 Subject: [PATCH 0/2] mx31moboard for 2.6.33-rc1 In-Reply-To: <1261156293-13981-1-git-send-email-valentin.longchamp@epfl.ch> References: <1261156293-13981-1-git-send-email-valentin.longchamp@epfl.ch> Message-ID: <20091221111726.GF15126@pengutronix.de> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Fri, Dec 18, 2009 at 06:11:31PM +0100, Valentin Longchamp wrote: > I have tested mx31moboard with the first -rc. Here are two patches correcting the current problems. They should go to a next -rc. > > 1) The patches for usbh support were based on the bad branch, where > the platform_devices had been renamed. Now this prevents the mx3 > config to build. The first patch reverts to the correct names. > > 2) The MC13783 voltage regulators with boot_on or always_on enabled > hang the kernel at boot. Remove these options from mx31moboard > configuration. Sascha, is this a correct behavior or is it a bug ? AFAIK the boot_on indicate the regulator framework that this regulator is already enabled when the kernel starts. I don't see why this makes the kernel hang. Can you do a bit more debugging please? Sascha -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |