From: Wolfgang Denk Date: Tue, 09 Feb 2010 21:52:23 +0100 Subject: [U-Boot] [PATCH] Support for the Calao USB-A9260/USB-A9G20 boards In-Reply-To: <1265637776-21295-1-git-send-email-gregory.hermant@calao-systems.com> References: <1265637776-21295-1-git-send-email-gregory.hermant@calao-systems.com> Message-ID: <20100209205223.2D80DA87D1A@gemini.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Dear Gregory Hermant, In message <1265637776-21295-1-git-send-email-gregory.hermant@calao-systems.com> you wrote: > The Calao USB-A9260 and USB-9G20 boards are manufactured and sold by Calao Systems > . They are built around an AT91SAM9260 ARM SoC > running at 180MHz and an AT91SAM9G20 ARM SoC running at 400MHz respectively. > They feature an Ethernet port, 64Mo of SDRAM, 256Mo of NAND flash, two USB host ports, > and an USB device port. They also feature a FTDI2232 converter which provides the ability > to use the DBGU serial port & the JTAG port over a USB interface. > > Signed-off-by: Gregory Hermant > --- ... > +#include > +#undef CONFIG_CMD_BDI > +#undef CONFIG_CMD_FPGA > +#undef CONFIG_CMD_IMI > +#undef CONFIG_CMD_IMLS > +#undef CONFIG_CMD_LOADS > +#undef CONFIG_CMD_SOURCE Is there any special reason for disabling these commands? They are usually considered pretty useful, and from the rest of your configuration I don't believe you try to minimize the memory footprint of the U-Boot image? Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de Time is a drug. Too much of it kills you. - Terry Pratchett, _Small Gods_