From: s.hauer@pengutronix.de (Sascha Hauer) Date: Thu, 6 May 2010 08:38:59 +0200 Subject: [PATCH 1/1] mx31smartbot: change the config of a gpio In-Reply-To: <1273052061-17147-1-git-send-email-valentin.longchamp@epfl.ch> References: <1273052061-17147-1-git-send-email-valentin.longchamp@epfl.ch> Message-ID: <20100506063859.GL31199@pengutronix.de> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Wed, May 05, 2010 at 11:34:21AM +0200, Valentin Longchamp wrote: > Since it is finally used on the handbot as a configuration input for > the translator. > > Signed-off-by: Valentin Longchamp Ok, added to mxc-master. Sascha > --- > arch/arm/mach-mx3/mx31moboard-smartbot.c | 8 ++++---- > 1 files changed, 4 insertions(+), 4 deletions(-) > > diff --git a/arch/arm/mach-mx3/mx31moboard-smartbot.c b/arch/arm/mach-mx3/mx31moboard-smartbot.c > index 52a69fc..83d2b9f 100644 > --- a/arch/arm/mach-mx3/mx31moboard-smartbot.c > +++ b/arch/arm/mach-mx3/mx31moboard-smartbot.c > @@ -119,7 +119,7 @@ static int __init smartbot_cam_init(void) > #define POWER_EN IOMUX_TO_GPIO(MX31_PIN_DTR_DCE1) > #define DSPIC_RST_B IOMUX_TO_GPIO(MX31_PIN_DSR_DCE1) > #define TRSLAT_RST_B IOMUX_TO_GPIO(MX31_PIN_RI_DCE1) > -#define SEL3 IOMUX_TO_GPIO(MX31_PIN_DCD_DCE1) > +#define TRSLAT_SRC_CHOICE IOMUX_TO_GPIO(MX31_PIN_DCD_DCE1) > > static void smartbot_resets_init(void) > { > @@ -138,9 +138,9 @@ static void smartbot_resets_init(void) > gpio_export(TRSLAT_RST_B, false); > } > > - if (!gpio_request(SEL3, "sel3")) { > - gpio_direction_input(SEL3); > - gpio_export(SEL3, true); > + if (!gpio_request(TRSLAT_SRC_CHOICE, "translator-src-choice")) { > + gpio_direction_output(TRSLAT_SRC_CHOICE, 0); > + gpio_export(TRSLAT_SRC_CHOICE, false); > } > } > /* > -- > 1.7.0.4 > > -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |