From: tbm@cyrius.com (Martin Michlmayr) Date: Tue, 25 May 2010 20:04:46 +0100 Subject: [PATCH] orion5x: Set links to solid on D-Link DNS-323 In-Reply-To: <20100326112030.GA29585@jirafa.cyrius.com> References: <20100326112030.GA29585@jirafa.cyrius.com> Message-ID: <20100525190446.GA27367@jirafa.cyrius.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org * Martin Michlmayr [2010-03-26 11:20]: > Among other changes, commit b2a731aa ("D-link DNS-323 revision A1 power > LED") changed the default behaviour of the power LED from solid to > blinking. This was done to match the original DNS-323 firmware which > blinks during the boot process and sets the LED to solid when booting > has completed. However, the downside of this behaviour is that it > requires userland code to change the LED, even for those who don't > care about the behaviour of the original firmware. Therefore, change > it to solid again and let those who care about the original behaviour > change the behaviour from userland. *ping* > Signed-off-by: Martin Michlmayr > > --- a/arch/arm/mach-orion5x/dns323-setup.c > +++ b/arch/arm/mach-orion5x/dns323-setup.c > @@ -262,7 +262,7 @@ static struct gpio_led dns323_leds[] = { > { > .name = "power:blue", > .gpio = DNS323_GPIO_LED_POWER2, > - .default_trigger = "timer", > + .default_trigger = "default-on", > }, { > .name = "right:amber", > .gpio = DNS323_GPIO_LED_RIGHT_AMBER, > > -- > Martin Michlmayr > http://www.cyrius.com/ > > _______________________________________________ > linux-arm-kernel mailing list > linux-arm-kernel at lists.infradead.org > http://lists.infradead.org/mailman/listinfo/linux-arm-kernel -- Martin Michlmayr http://www.cyrius.com/