From: Thorsten =?iso-8859-1?q?M=FChlfelder?= Date: Fri, 28 May 2010 11:34:01 +0200 Subject: [U-Boot] No network in Linux on Olimex SAM9_L9260 (Atmel AT91SAM9260EK) In-Reply-To: References: <201005281029.30633.muehlfelder@enertex.de> Message-ID: <201005281134.01543.muehlfelder@enertex.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Am Friday 28 May 2010 11:05:58 schrieben Sie: > Hi Thorsten, > > 2010/5/28 Thorsten M?hlfelder : > > So I've decided to compile a new U-Boot. > > > > My Toolchain is Codesourcery 2010q1 on a 32 bit Slackware Linux and I've > > used U-Boot 2010.03 sources. > > The board runs a 2.6.24-rt kernel with patch for Olimex support. > > > > As the Olimex board is heavily based on the Atmel AT91SAM9260EK board > > I've decided to build U-Boot for this one. I only had to tweak the > > machine type so that Linux can be started. > > I've done the same on earlier occasions, although I can't remember if > it worked or not. > > However, in my latest project, I've used U-Boot 2009.08, together with > a selected sets of the patches from Olimex. > http://www.olimex.com/dev/soft/arm/SAM9/u-boot-olimex-patches-20090717.tgz > > It shouldn't be too hard to apply them to a later U-Boot-version, > although minor changes might be needed. Hey, I've found these patches, too. But I had problems compiling a patched U-Boot, even if I tried older U-Boot versions and older toolchain versions. I could fix some compiler errors, but not all of them. But I should have taken a closer look to the patch set, because... > If you don't go for the Olimex patches, take Eric's advise and check > the MII and RMII settings. It's clearly stated in the patch, that I had to #undef CONFIG_RMII?but I just did not see it. Probably it was to late in the evening yesterday :-D > Regards, > Anders Regards Thorsten