From: plagnioj@jcrosoft.com (Jean-Christophe PLAGNIOL-VILLARD) Date: Fri, 10 Sep 2010 18:16:21 +0200 Subject: [PATCH] ARM: make TCM allocation static and common for all archs In-Reply-To: <1278717389-8964-1-git-send-email-linus.walleij@stericsson.com> References: <1278717389-8964-1-git-send-email-linus.walleij@stericsson.com> Message-ID: <20100910161621.GF21361@game.jcrosoft.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 01:16 Sat 10 Jul , Linus Walleij wrote: > This changes the TCM handling so that a fixed area is reserved at > 0xfffe0000-0xfffeffff for TCM. This areas is used by XScale but > XScale does not have TCM so the mechanisms are mutually exclusive. > > This change is needed to make TCM detection more dynamic while > still being able to compile code into it, and is a must for the > unified ARM goals: the current TCM allocation at different places > in memory for each machine would be a nightmare if you want to > compile a single image for more than one machine with TCM so it > has to be nailed down in one place. > > Signed-off-by: Linus Walleij > --- > This is another TCM patch, to be applied on top of the other > stuff I've sent so far. This has been tested on U300 and PB1176 > however I haven't sent a patch for activating TCM on the RealViews > just yet, because I want to check the potential SMP issues that > would affect some of them. It would probably be possible to add > it on the mach-versatile though. (I don't have one.) > --- Any feed back about the tcm? Best Regards, J.