From: Wolfgang Denk Date: Thu, 16 Sep 2010 09:13:26 +0200 Subject: [U-Boot] U-Boot debug - Error In-Reply-To: <29725451.post@talk.nabble.com> References: <29725451.post@talk.nabble.com> Message-ID: <20100916071326.C7C8C15242D@gemini.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Dear manojatl, In message <29725451.post@talk.nabble.com> you wrote: > > We are using tool chain gnuarm 3.4.3 to compile U-Boot 1.1.6 for SMDK2400 > board (ARM 9). The commands were as follows. GCC 3.4.3 was released 6.5 years ago. U-Boot 1.1.6 was released 4.5 years ago. These versions are extremenly old. Instead of wasting your time trying to get this ancient stuff running, I strongly recommend to update to more recent versions of both the tool chain and U-Boot. Apart from that, to the best of my knowledge the SMDK2400 board support has always been working in all official releases of U-Boot that contain support for this board. IF you see problems, it is highly likely that these be caused by your tool chain - gcc 3.4.x has always had a number of issues. As stated before: update and use current tools and code. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de He'd heard her use that sweet, innocent tone of voice before. It meant that, pretty soon, there was going to be trouble. - Terry Pratchett, _Truckers_