From: Tony Lindgren Subject: [PATCH 3/7] omap: Beagle: only Cx boards use pin 23 for write protect Date: Fri, 24 Sep 2010 17:27:10 -0700 Message-ID: <20100925002710.24551.64851.stgit@baageli.muru.com> References: <20100925002608.24551.67183.stgit@baageli.muru.com> Mime-Version: 1.0 Content-Type: text/plain; charset="utf-8" Content-Transfer-Encoding: 7bit Return-path: Received: from mho-02-ewr.mailhop.org ([204.13.248.72]:61137 "EHLO mho-02-ewr.mailhop.org" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1752518Ab0IYA1I (ORCPT ); Fri, 24 Sep 2010 20:27:08 -0400 In-Reply-To: <20100925002608.24551.67183.stgit@baageli.muru.com> Sender: linux-omap-owner@vger.kernel.org List-Id: linux-omap@vger.kernel.org To: linux-arm-kernel@lists.infradead.org Cc: Jarkko Nikula , linux-omap@vger.kernel.org, Robert Nelson From: Robert Nelson system_rev comes from u-boot and is a constant 0x20, so Bx boards also fall in this 'if' and will get setup with the wrong gpio_wp pin. Switch to using the Beagle revision routine to correcly set pin 23 only for C1/2/3 and C4 Boards. Bx boards will then use the correct default pin setting. Signed-off-by: Robert Nelson Acked-by: Jarkko Nikula Signed-off-by: Tony Lindgren --- arch/arm/mach-omap2/board-omap3beagle.c | 3 ++- 1 files changed, 2 insertions(+), 1 deletions(-) diff --git a/arch/arm/mach-omap2/board-omap3beagle.c b/arch/arm/mach-omap2/board-omap3beagle.c index 1aebb3f..1908b33 100644 --- a/arch/arm/mach-omap2/board-omap3beagle.c +++ b/arch/arm/mach-omap2/board-omap3beagle.c @@ -272,7 +272,8 @@ static struct gpio_led gpio_leds[]; static int beagle_twl_gpio_setup(struct device *dev, unsigned gpio, unsigned ngpio) { - if (system_rev >= 0x20 && system_rev <= 0x34301000) { + if ((omap3_beagle_get_rev() == OMAP3BEAGLE_BOARD_C1_3) || + (omap3_beagle_get_rev() == OMAP3BEAGLE_BOARD_C4)) { omap_mux_init_gpio(23, OMAP_PIN_INPUT); mmc[0].gpio_wp = 23; } else {