From: Wolfgang Denk Date: Tue, 12 Oct 2010 17:14:48 +0200 Subject: [U-Boot] [PATCH 4/4] MX51: Add video support to vision2 board In-Reply-To: <4CB479A1.6060108@denx.de> References: <1286875504-9058-1-git-send-email-sbabic@denx.de> <1286875504-9058-2-git-send-email-sbabic@denx.de> <1286875504-9058-3-git-send-email-sbabic@denx.de> <1286875504-9058-4-git-send-email-sbabic@denx.de> <1286875504-9058-5-git-send-email-sbabic@denx.de> <20101012113723.CA3D114F310@gemini.denx.de> <4CB479A1.6060108@denx.de> Message-ID: <20101012151448.856F814F310@gemini.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Dear stefano babic, In message <4CB479A1.6060108@denx.de> you wrote: > > > Normally one defines a default command here ? > > Probably I misunderstand its usage, but my intention is to enable the > PREBOOT feature, but let the user to decide with the "preboot" variable > if it is required or not. In my case for this board, I use it to load an > image from a NAND device, as "splashimage" can be used only with an address. No, you did not misinderstand. Everything is fine if this was your intention. I just wantred to make that sure, as most people define some default command here. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de We fight only when there is no other choice. We prefer the ways of peaceful contact. -- Kirk, "Spectre of the Gun", stardate 4385.3