From: Wolfgang Denk Date: Sun, 21 Nov 2010 15:11:59 +0100 Subject: [U-Boot] Debugger(BDI3000) Error ! In-Reply-To: <549623.8431.qm@web120303.mail.ne1.yahoo.com> References: <549623.8431.qm@web120303.mail.ne1.yahoo.com> Message-ID: <20101121141159.87A04134FEF@gemini.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Dear Tim Rachman, In message <549623.8431.qm@web120303.mail.ne1.yahoo.com> you wrote: > > I use BDI3000 debugger to debug my custom board using PPC440EP , using Yosemite > config file as base. > After board power on following messages are shown: > > - TARGET: waiting for target Vcc > - TARGET: processing power-up delay > - TARGET: processing user reset request > - TARGET: resetting target passed > - TARGET: processing target startup .... > - TARGET: core #0 PVR is 0x422218D4 > - TARGET: processing target startup passed > 440EP>go > 440EP> This looks good... > > According to BDI3000 manual it's expected to see this message after go command: > > - TARGET: core #0 has entered debug mode > > But i don't have it. This depends on how you reset your board. Pleas enote that there are several variabts of the "reset" command. "reset run" works quite differently from "reset halt". The BI stores the last use, so when you just type "reset" it repeats the last mode. > Is there any idea about this error? I don't see any error. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de The most difficult thing in the world is to know how to do a thing and to watch someone else doing it wrong, without commenting. -- T.H. White