From: tony@atomide.com (Tony Lindgren) Date: Fri, 17 Dec 2010 19:05:36 -0800 Subject: [PATCH 4/6] omap3: igepv2: LED gpio-led:green:d1 is active low In-Reply-To: <20101218030406.10251.73118.stgit@baageli.muru.com> References: <20101218030406.10251.73118.stgit@baageli.muru.com> Message-ID: <20101218030536.10251.87298.stgit@baageli.muru.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org From: Laurent Pinchart Make sure the LED is turned off at boot time, and configure the GPIO LED device as active low. Signed-off-by: Laurent Pinchart Acked-by: Enric Balletbo i Serra Signed-off-by: Tony Lindgren --- arch/arm/mach-omap2/board-igep0020.c | 3 ++- 1 files changed, 2 insertions(+), 1 deletions(-) diff --git a/arch/arm/mach-omap2/board-igep0020.c b/arch/arm/mach-omap2/board-igep0020.c index 77e2db7..c5bd537 100644 --- a/arch/arm/mach-omap2/board-igep0020.c +++ b/arch/arm/mach-omap2/board-igep0020.c @@ -352,6 +352,7 @@ static struct gpio_led igep2_gpio_leds[] = { .name = "gpio-led:green:d1", .default_trigger = "heartbeat", .gpio = -EINVAL, /* gets replaced */ + .active_low = 1, }, }; @@ -423,7 +424,7 @@ static int igep2_twl_gpio_setup(struct device *dev, /* TWL4030_GPIO_MAX + 1 == ledB (out, active low LED) */ #if !defined(CONFIG_LEDS_GPIO) && !defined(CONFIG_LEDS_GPIO_MODULE) if ((gpio_request(gpio+TWL4030_GPIO_MAX+1, "gpio-led:green:d1") == 0) - && (gpio_direction_output(gpio + TWL4030_GPIO_MAX + 1, 0) == 0)) + && (gpio_direction_output(gpio + TWL4030_GPIO_MAX + 1, 1) == 0)) gpio_export(gpio + TWL4030_GPIO_MAX + 1, 0); else pr_warning("IGEP v2: Could not obtain gpio GPIO_LED1_GREEN\n");