From: "Henrik Rydberg" Date: Sat, 18 Dec 2010 09:07:14 +0000 Subject: Re: [lm-sensors] [PATCH 1/2 V3] applesmc: Use PnP rather than Message-Id: <20101218090714.GA436@polaris.bitmath.org> List-Id: References: <20101217221618.GA13207@ericsson.com> <1292624661-32474-1-git-send-email-mjg@redhat.com> <20101218042320.GA14104@ericsson.com> In-Reply-To: <20101218042320.GA14104@ericsson.com> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: Guenter Roeck Cc: Matthew Garrett , "linux-kernel@vger.kernel.org" , "lm-sensors@lm-sensors.org" On Fri, Dec 17, 2010 at 08:23:21PM -0800, Guenter Roeck wrote: > On Fri, Dec 17, 2010 at 05:24:20PM -0500, Matthew Garrett wrote: > > The AppleSMC device is described in ACPI, including a list of its resources. > > We should use those rather than hardcoding the ports. A side-effect is that > > we can then remove the DMI matching, since there's a unique identifier to > > indicate that the machine has one of these devices. > > > > Signed-off-by: Matthew Garrett > > You added a whitespace error, and kfree() is safe and doesn't need a check. > I fixed those, so no need to resubmit. If Henrik gives his Ack we are ready to go. Thanks, I will give it some testing before doing so. Matthew, did you test this under EFI boot? Also, NOTIFICATION_KEY does not seem to be used anywhere. Henrik _______________________________________________ lm-sensors mailing list lm-sensors@lm-sensors.org http://lists.lm-sensors.org/mailman/listinfo/lm-sensors