From: "Henrik Rydberg" Date: Sat, 18 Dec 2010 10:31:39 +0000 Subject: Re: [lm-sensors] [PATCH 1/2 V3] applesmc: Use PnP rather than Message-Id: <20101218103139.GA1668@polaris.bitmath.org> List-Id: References: <20101217221618.GA13207@ericsson.com> <1292624661-32474-1-git-send-email-mjg@redhat.com> <20101218042320.GA14104@ericsson.com> <20101218093719.GA1493@polaris.bitmath.org> <20101218110954.7a2ca190@endymion.delvare> In-Reply-To: <20101218110954.7a2ca190@endymion.delvare> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: Jean Delvare Cc: Guenter Roeck , "lm-sensors@lm-sensors.org" , "linux-kernel@vger.kernel.org" , Matthew Garrett On Sat, Dec 18, 2010 at 11:09:54AM +0100, Jean Delvare wrote: > On Sat, 18 Dec 2010 10:37:19 +0100, Henrik Rydberg wrote: > > So where to attach the sysfs nodes... There is also a userspace issue > > here, since a lot of applications are hard-wired to > > /sys/devices/platform/applesmc.768/. > > Which applications? libsensors-based applications definitely don't > hard-wire anything. The ones I am thinking of are pommed and macfanctld, there are probably others. The sysfs nodes have been around a while, so it is not really surprising. If there is a policy saying it is ok to break userspace in this case, that's fine. Henrik _______________________________________________ lm-sensors mailing list lm-sensors@lm-sensors.org http://lists.lm-sensors.org/mailman/listinfo/lm-sensors