From: Paul Mackerras Date: Tue, 21 Dec 2010 22:44:00 +0000 Subject: Re: [PATCH] ppp: allow disabling multilink protocol ID compression Message-Id: <20101221224400.GA17383@brick.ozlabs.ibm.com> List-Id: References: <20101220195833.26786ec5@nehalam> In-Reply-To: <20101220195833.26786ec5@nehalam> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: Stephen Hemminger Cc: linux-ppp@vger.kernel.org, netdev@vger.kernel.org On Mon, Dec 20, 2010 at 07:58:33PM -0800, Stephen Hemminger wrote: > Linux would not connect to other router running old version Cisco IOS (12.0). > This is most likely a bug in that version of IOS, since it is fixed > in later versions. As a workaround this patch allows a module parameter > to be set to disable compressing the protocol ID. > > See: https://bugzilla.vyatta.com/show_bug.cgi?id979 > > RFC 1990 allows an implementation to formulate MP fragments as if protocol > compression had been negotiated. This allows us to always send compressed > protocol IDs. But some implementations don't accept MP fragments with > compressed protocol IDs. This parameter allows us to interoperate with > them. The default value of the configurable parameter is the same as the > current behavior: protocol compression is enabled. If protocol compression > is disabled we will not send compressed protocol IDs. > > This is based on an earlier patch by Bob Gilligan (using a sysctl). > Module parameter is writable to allow for enabling even if ppp > is already loaded for other uses. > > Signed-off-by: Stephen Hemminger Acked-by: Paul Mackerras