From: u.kleine-koenig@pengutronix.de (Uwe =?iso-8859-1?Q?Kleine-K=F6nig?=) Date: Wed, 29 Dec 2010 09:14:19 +0100 Subject: [PATCH v2 1/8] ARM: mx5: use config to define boot related addresses In-Reply-To: <1293607828-21213-1-git-send-email-richard.zhao@freescale.com> References: <1293607828-21213-1-git-send-email-richard.zhao@freescale.com> Message-ID: <20101229081419.GM14221@pengutronix.de> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Wed, Dec 29, 2010 at 03:30:23PM +0800, Richard Zhao wrote: > Signed-off-by: Richard Zhao > --- > Because common clock is change, I don't send out mx50 clock and board level code. > But sure I tested the patch series using the clock/board code. > arch/arm/mach-mx5/Makefile.boot | 6 +++--- > 1 files changed, 3 insertions(+), 3 deletions(-) > > diff --git a/arch/arm/mach-mx5/Makefile.boot b/arch/arm/mach-mx5/Makefile.boot > index 9939a19..388d2e8 100644 > --- a/arch/arm/mach-mx5/Makefile.boot > +++ b/arch/arm/mach-mx5/Makefile.boot > @@ -1,3 +1,3 @@ > - zreladdr-y := 0x90008000 > -params_phys-y := 0x90000100 > -initrd_phys-y := 0x90800000 > + zreladdr-$(CONFIG_SOC_IMX51) := 0x90008000 > +params_phys-$(CONFIG_SOC_IMX51) := 0x90000100 > +initrd_phys-$(CONFIG_SOC_IMX51) := 0x90800000 I'd prefer to use CONFIG_MACH_MX51 here. Uwe -- Pengutronix e.K. | Uwe Kleine-K?nig | Industrial Linux Solutions | http://www.pengutronix.de/ |