From: Mark Brown Subject: Re: wm8974 and sam9g45 atmel Date: Fri, 10 Jun 2011 11:31:18 +0100 Message-ID: <20110610103118.GA26441@sirena.org.uk> References: <4DF0E2B4.7040401@ecsproject.com> Mime-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit Return-path: Received: from cassiel.sirena.org.uk (cassiel.sirena.org.uk [80.68.93.111]) by alsa0.perex.cz (Postfix) with ESMTP id 29A2E103826 for ; Fri, 10 Jun 2011 12:31:19 +0200 (CEST) Content-Disposition: inline In-Reply-To: <4DF0E2B4.7040401@ecsproject.com> List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Sender: alsa-devel-bounces@alsa-project.org Errors-To: alsa-devel-bounces@alsa-project.org To: Michele Da Rold Cc: dp@opensource.wolfsonmicro.com, alsa-devel@alsa-project.org List-Id: alsa-devel@alsa-project.org On Thu, Jun 09, 2011 at 05:11:48PM +0200, Michele Da Rold wrote: > Hello everybody, I'm starting a new development with a Atmel SAM9G45 and > a WM8974. Please always CC maintainers on mails - traffic on the mailing list is easily lost. > I'm using kernel 2.6.33.2 This kernel is *very* old - I would strongly recommend updating to a more current kernel if you're looking for support. > Putting some dedug messagge the driver not call the function > "set_bias_level", and call the mute function with mute=0. > Testing the MCLK signal I not see any clock on pin because I never call > clk_enable!! Have you routed audio from the DAI to an output using the ALSA controls? If you haven't connected an output path up then the kernel won't power anything on.