From: Guenter Roeck Date: Mon, 27 Jun 2011 13:42:39 +0000 Subject: Re: [lm-sensors] coretemp: Support for Intel Atom E6XX CPU Message-Id: <20110627134239.GA10808@ericsson.com> List-Id: References: <201106271220.51953.alexander.stein@systec-electronic.com> In-Reply-To: <201106271220.51953.alexander.stein@systec-electronic.com> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: Alexander Stein Cc: Fenghua Yu , Jean Delvare , "lm-sensors@lm-sensors.org" , "linux-kernel@vger.kernel.org" On Mon, Jun 27, 2011 at 06:20:51AM -0400, Alexander Stein wrote: > Hello, > > I have a patch (for v2.6.39) which adds support for Intel Atom E6XX > (TunnelCreek) to coretemp. It's merely only adding x86_model 0x26. > But there are models (e.g. E660 and E660T) with different TjMax, namely 90 > degrees C and 110 degrees C. But these different model can't be detected by > reading from hardware. > IMO there should be some support to adjust the temperature from userspace. > Reading Documentation/hwmon/sysfs-interface only temp1_offset seems to be > useable. But I think it is somewhat misleading (especially on multicores), > because there must only be one offset. > What do you think about this? > You can adjust the reported temperature with an entry in sensors3.conf. Guenter _______________________________________________ lm-sensors mailing list lm-sensors@lm-sensors.org http://lists.lm-sensors.org/mailman/listinfo/lm-sensors