From: Mike Frysinger Date: Fri, 19 Aug 2011 18:28:04 -0400 Subject: [U-Boot] [PATCH v3] Add 'sf update' command to do smart SPI flash update In-Reply-To: References: <1313782128-7252-1-git-send-email-sjg@chromium.org> <201108191715.08470.vapier@gentoo.org> Message-ID: <201108191828.05365.vapier@gentoo.org> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Friday, August 19, 2011 17:25:10 Simon Glass wrote: > On Fri, Aug 19, 2011 at 3:15 PM, Mike Frysinger wrote: > > On Friday, August 19, 2011 15:28:48 Simon Glass wrote: > >> This adds a new SPI flash command which only rewrites blocks if the > >> contents need to change. This can speed up SPI flash programming when > >> much of the data is unchanged from what is already there. > > > > looks good to me. i'll give it a spin on a board of mine and then push > > into my sf branch. i really should write a spi flash simulation so i > > could just test this from gdb ... > > Funny you should say that. I rather badly need a way of testing the > higher level U-Boot code (from the commands down to where it calls > architecture/driver code). I am drafting up an email to send to the > list with some thoughts on the matter. when i wrote the blackfin system level port of the gnu sim, it was so i could do this (and i thought it'd be bad-ass). i often use the gnu sim to do initial testing (sometimes down to the driver level) before i get around to loading up on actual hardware. $ bfin-elf-run --env operating --model bf537 ./u-boot U-Boot 2011.06-00375-g23ffb39-dirty (Aug 14 2011 - 16:54:03) CPU: ADSP bf537-0.2 (Detected Rev: 0.0) (bypass boot) Board: ADI BF537 stamp board Support: http://blackfin.uclinux.org/ Clock: VCO: 500 MHz, Core: 500 MHz, System: 125 MHz RAM: 64 MiB Flash: ## Unknown flash on Bank 1 - Size = 0x00000000 = 0 MB 0 Bytes MMC: *** Warning - bad CRC, using default environment In: serial Out: serial Err: serial KGDB: [on serial] ready Warning: Generating 'random' MAC address Net: bfin_mac Hit any key to stop autoboot: 5 0 bfin> help sf sf - SPI flash sub-system Usage: sf probe [bus:]cs [hz] [mode] - init flash device on given SPI bus and chip select sf read addr offset len - read `len' bytes starting at `offset' to memory at `addr' sf write addr offset len - write `len' bytes from memory at `addr' to flash at `offset' sf erase offset [+]len - erase `len' bytes from `offset' `+len' round up `len' to block size bfin> -mike -------------- next part -------------- A non-text attachment was scrubbed... Name: not available Type: application/pgp-signature Size: 836 bytes Desc: This is a digitally signed message part. Url : http://lists.denx.de/pipermail/u-boot/attachments/20110819/4627a91d/attachment.pgp