From: Kurt Van Dijck Subject: Re: using can-j1939 Date: Sat, 17 Dec 2011 20:20:38 +0100 Message-ID: <20111217192038.GA309@e-circ.dyndns.org> References: <20111215092018.GB321@e-circ.dyndns.org> <20111215120434.GD321@e-circ.dyndns.org> <20111215140012.GA10848@e-circ.dyndns.org> <20111216083708.GA323@e-circ.dyndns.org> <20111216093308.GB669@e-circ.dyndns.org> Mime-Version: 1.0 Content-Type: text/plain; charset=utf-8 Return-path: Received: from mailrelay005.isp.belgacom.be ([195.238.6.171]:64586 "EHLO mailrelay005.isp.belgacom.be" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1752404Ab1LQTUl (ORCPT ); Sat, 17 Dec 2011 14:20:41 -0500 Content-Disposition: inline In-Reply-To: Sender: linux-can-owner@vger.kernel.org List-ID: To: Wolfgang Cc: linux-can@vger.kernel.org On Fri, Dec 16, 2011 at 02:29:45PM +0000, Wolfgang wrote: > > > The packets are destination specific. > > > But I was wrong the, it should read and > > > write from both bus' - sorry, but only 2 specific address'! > > Even that is no problem... > > OK, this sounds great. I am just browsing through the documentation and wondering > if it is possible to activate j1939 per default, Of course this is possible, but unwanted. This choice is comparable to "not setting 250Kb per default". Read more below. > that it would be possible to use > the target as stand alone. You should initialize the CAN bus(ses) on powerup: * set baudrate * set j1939 on * set iface up. Typically this is done in some init scripts. Kind regards, Kurt