From: arnd@arndb.de (Arnd Bergmann) Date: Fri, 4 May 2012 12:56:30 +0000 Subject: [PATCH 3/9] ARM: mmp: support DT in irq In-Reply-To: References: <1335515957-1798-1-git-send-email-haojian.zhuang@gmail.com> <201205021251.16967.arnd@arndb.de> Message-ID: <201205041256.30409.arnd@arndb.de> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Friday 04 May 2012, Haojian Zhuang wrote: > On Wed, May 2, 2012 at 8:51 PM, Arnd Bergmann wrote: > > On Wednesday 02 May 2012, Haojian Zhuang wrote: > >> I use two CONFIG_OF in this file. The first one is used to record > >> register base address > >> of interrupt controller. In legacy code, the register address is > >> hardcoding. Do you mean > >> that I should remove this CONFIG_OF? > > > > Unless it's a noticeable performance impact, I would recommend just > > always using the mmp_icu_base variable, even for when CONFIG_OF is > > disabled. > > But I appended new irq handler for DT support. I still need to reserve > this CONFIG_OF > since I need to keep compatible with legacy code. You don't need to worry about out-of-tree code, it can adapt. For the non-DT version, why can't you move the 'mmp_icu_base' variable into common.c and just initialize it to ICU_VIRT_BASE? If you do that, any combination of DT- and non-DT board files should work with the same entry-macro.S code. Another alternative would be to convert MMP over to CONFIG_MULTI_IRQ_HANDLER and use different handle_irq functions. Arnd