From: will.deacon@arm.com (Will Deacon) Date: Mon, 17 Dec 2012 13:42:46 +0000 Subject: ARM realview breakages w/ 3.7 under qemu In-Reply-To: <50CB0150.1000901@openwrt.org> References: <50CA0FC1.5090009@openwrt.org> <20121213174817.GB12946@mudshark.cambridge.arm.com> <20121214094012.GG14363@n2100.arm.linux.org.uk> <50CB0150.1000901@openwrt.org> Message-ID: <20121217134246.GE11558@mudshark.cambridge.arm.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Fri, Dec 14, 2012 at 10:37:04AM +0000, Florian Fainelli wrote: > Le 12/14/12 10:40, Russell King - ARM Linux a ?crit : > > On Thu, Dec 13, 2012 at 05:48:17PM +0000, Will Deacon wrote: > >> On Thu, Dec 13, 2012 at 05:26:25PM +0000, Florian Fainelli wrote: > >>> - PBX A9: booting with less than 1024MBytes of RAM causes this: > >>> [ 0.000000] Truncating RAM at 20000000-3fffffff to -3f7fffff (vmalloc > >>> region overlap). > >>> [ 0.000000] Ignoring RAM at 80000000-8fffffff (vmalloc region overlap). > >>> > >>> Do these issues sounds familiar to any of you? The kernel config is > >>> attached in case that helps. > > I don't have the original email to reply to (so I don't have the .config > > either) but my guess for the above would be that HIGHMEM is disabled. > The original mail containing the .config file was actually rejected by > the mailing-list manager. I have uploaded it here: > http://alphacore.org/~florian/openwrt/realview-eb-config > > You are right, HIGHMEM is disabled. Even though enabling HIGHMEM does > not allow me booting either without at least 1Gbyte of RAM: > > [ 0.000000] Memory policy: ECC disabled, Data cache writealloc > and we are stuck. I just dusted off my pbx and it boots fine with your .config and a 3.7 kernel when passing mem=128M on the command line. For EB, can you try the following diff please? Will --->8 diff --git a/arch/arm/mach-realview/include/mach/board-eb.h b/arch/arm/mach-realview/include/mach/board-eb.h index 124bce6..a301e61 100644 --- a/arch/arm/mach-realview/include/mach/board-eb.h +++ b/arch/arm/mach-realview/include/mach/board-eb.h @@ -47,7 +47,7 @@ #define REALVIEW_EB_USB_BASE 0x4F000000 /* USB */ #ifdef CONFIG_REALVIEW_EB_ARM11MP_REVB -#define REALVIEW_EB11MP_PRIV_MEM_BASE 0x1F000000 +#define REALVIEW_EB11MP_PRIV_MEM_BASE 0x10100000 #define REALVIEW_EB11MP_L220_BASE 0x10102000 /* L220 registers */ #define REALVIEW_EB11MP_SYS_PLD_CTRL1 0xD8 /* Register offset for MPCore sysctl */ #else