From: Wolfgang Denk Date: Thu, 20 Dec 2012 13:49:25 +0100 Subject: [U-Boot] [U-Boot, v2 1/6] cmd_sf: Add print messages on flash erase command In-Reply-To: References: <1355934463-24319-1-git-send-email-jagannadh.teki@gmail.com> <20121219231637.6535D202B12@gemini.denx.de> Message-ID: <20121220124925.A7E9C202B6F@gemini.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Dear Jagan Teki, In message you wrote: > > Apart from this sometimes (very rare) due to the slowness of UART or SPI flash > even if we run the sf commands it will not execute the actual code > just terminate with showing > u-boot prompt, so the user assumes that this command is happen > properly. [but actually command is not done] But that would be a different thing - if there are errors without clear error messages, this is a bug that needs fixing. [But I do not see which part of your patch would address such an issue. Am I missing something?] Adding verbose progress messages is a different thing, though. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de It is much easier to suggest solutions when you know nothing