From: horms@verge.net.au (Simon Horman) Date: Thu, 14 Feb 2013 12:34:04 +0900 Subject: [PATCH 00/06] ARM: shmobile: SMP Cortex-A9 SCU rework In-Reply-To: <20130213134628.12153.47120.sendpatchset@w520> References: <20130213134628.12153.47120.sendpatchset@w520> Message-ID: <20130214033403.GR15879@verge.net.au> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Wed, Feb 13, 2013 at 10:46:28PM +0900, Magnus Damm wrote: > ARM: shmobile: SMP Cortex-A9 SCU rework > > [PATCH 01/06] ARM: shmobile: Kill off sh73a0 scu_base_addr() function > [PATCH 02/06] ARM: shmobile: Kill off r8a7779 scu_base_addr() function > [PATCH 03/06] ARM: shmobile: Rework EMEV2 scu_base variable > [PATCH 04/06] ARM: shmobile: Move headsmp-sh73a0.S to headsmp-scu.S > [PATCH 05/06] ARM: shmobile: Common shmobile_scu_base in headsmp-scu.S > [PATCH 06/06] ARM: shmobile: Update EMEV2 to use scu_power_mode() > > Rework the EMEV2 SMP code to make use of common scu_power_mode() > code together with a shared shmobile_scu_base and early SCU > setup code in headsmp-scu.S. > > The patches are known to build for sh73a0, r8a7779 and EMEV2. > > Note that the code has only been tested on the KZM9D/EMEV2 board, > and because of that changes to other boards have been kept at > a minimum. Next target after this is to update the r8a7779 SMP/SCU > code to make use of scu_base_addr(), but that requires hardware > access for testing. I have tested this on the kzm9g/sh73a0, marzen/r8a7779 and kzm9d/emev2. I have applied the entire series to the soc5 branch thus queued up for v3.10. It is also in the next branch and thus should appear in linux-next in the not to distant future.