From: balbi@ti.com (Felipe Balbi) Date: Fri, 15 Feb 2013 15:07:45 +0200 Subject: [RFC/RFT PATCH 0/2] SERIAL: OMAP: Remove idle handling from driver In-Reply-To: <511E323E.3050104@ti.com> References: <1360929970-31934-1-git-send-email-santosh.shilimkar@ti.com> <511E323E.3050104@ti.com> Message-ID: <20130215130745.GC16558@arwen.pp.htv.fi> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Fri, Feb 15, 2013 at 06:33:58PM +0530, a0131647 wrote: > Hi, > On Friday 15 February 2013 05:36 PM, Santosh Shilimkar wrote: > >OMAP UART IP needs manual idle modes based on state of the > >IP. Currently this is handled by the driver with function pointers > >implemented in platform code. > > > >This however breaks in case of device tree because of missing > >idle handling. > > > >The series tries to address the issue > > > >Patches has been tested on OMAP4 and OMAP5 devices where the console > >slugishness was observed without idle mode handling. CPUIDLE and > >suspend tested ok on these devices. > > > >Need help in testing on OMAP2, OMAP3 and AM3XXX devices. > > > Tested this series on omap3630 beagle board for: > 1. Retention in idle and suspend. > 2. Off mode in idle and suspend. > > Tested-by: Sourav Poddar try setting autosuspend_delay to -1 -- balbi -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 836 bytes Desc: Digital signature URL: