From: balbi@ti.com (Felipe Balbi) Date: Sat, 2 Mar 2013 13:48:11 +0200 Subject: [PATCH 1/2] gpio/omap: convert gpio irq domain to linear mapping In-Reply-To: <1362158568-1624-2-git-send-email-jon-hunter@ti.com> References: <1362158568-1624-1-git-send-email-jon-hunter@ti.com> <1362158568-1624-2-git-send-email-jon-hunter@ti.com> Message-ID: <20130302114742.GA9965@arwen.pp.htv.fi> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Fri, Mar 01, 2013 at 11:22:47AM -0600, Jon Hunter wrote: > Currently the OMAP GPIO driver uses a legacy mapping for the GPIO IRQ > domain. This is not necessary because we do not need to assign a > specific interrupt number to the GPIO IRQ domain. Therefore, convert > the OMAP GPIO driver to use a linear mapping instead. > > Please note that this also allows to simplify the logic in the OMAP > gpio_irq_handler() routine, by using irq_find_mapping() to obtain the > virtual irq number from the GPIO bank and bank index. > > Reported-by: Linus Walleij > Signed-off-by: Jon Hunter Reviewed-by: Felipe Balbi Just one suggestion below for a later patch. > @@ -680,7 +686,7 @@ static void gpio_irq_handler(unsigned int irq, struct irq_desc *desc) > { > void __iomem *isr_reg = NULL; > u32 isr; > - unsigned int gpio_irq, gpio_index; > + unsigned int i; > struct gpio_bank *bank; > int unmasked = 0; > struct irq_chip *chip = irq_desc_get_chip(desc); > @@ -721,15 +727,10 @@ static void gpio_irq_handler(unsigned int irq, struct irq_desc *desc) > if (!isr) > break; > > - gpio_irq = bank->irq_base; > - for (; isr != 0; isr >>= 1, gpio_irq++) { > - int gpio = irq_to_gpio(bank, gpio_irq); > - > + for (i = 0; isr != 0; isr >>= 1, i++) { > if (!(isr & 1)) > continue; this will iterate over all 32 GPIOs, a better way to handle this would be to have something like: while (isr) { unsigned long bit = __ffs(isr); /* clear this bit */ isr &= ~bit; generic_handle_irq(irq_find_mapping(bank->domain, bit); } this way you will only iterate the amount of bits enabled in the isr register. ps: completely untested ;-) -- balbi -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 836 bytes Desc: Digital signature URL: