From: ludovic.desroches@atmel.com (Ludovic Desroches) Date: Wed, 13 Mar 2013 11:25:07 +0100 Subject: [PATCH 2/2] arm: at91: dt: at91sam9x5: add i2c-gpio pinctrl In-Reply-To: <1363107286-25698-2-git-send-email-richard.genoud@gmail.com> References: <1363107286-25698-1-git-send-email-richard.genoud@gmail.com> <1363107286-25698-2-git-send-email-richard.genoud@gmail.com> Message-ID: <20130313102507.GB9249@ludovic.desroches@atmel.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Tue, Mar 12, 2013 at 05:54:46PM +0100, Richard Genoud wrote: > i2c-gpio is sometimes used in place of i2c-at91. > This adds the pin muxes for the gpios. > > Signed-off-by: Richard Genoud Since i2c-gpio nodes are already in the a91sam9x5 why not adding pin muxes. If not, we should remove these nodes but I think it is quite convenient to keep them in order to easily switch from i2c-at91 to i2c-gpio for debug purpose or others. Acked-by: Ludovic Desroches > --- > based on v3.9-rc2 > > arch/arm/boot/dts/at91sam9x5.dtsi | 30 ++++++++++++++++++++++++++++++ > 1 files changed, 30 insertions(+), 0 deletions(-) > > diff --git a/arch/arm/boot/dts/at91sam9x5.dtsi b/arch/arm/boot/dts/at91sam9x5.dtsi > index 8cbcff4..d18aff5 100644 > --- a/arch/arm/boot/dts/at91sam9x5.dtsi > +++ b/arch/arm/boot/dts/at91sam9x5.dtsi > @@ -343,6 +343,30 @@ > }; > }; > > + i2c_gpio0 { > + pinctrl_i2c_gpio0: i2c_gpio0-0 { > + atmel,pins = > + <0 30 0x0 0x2 /* PA30 gpio multidrive I2C0 data */ > + 0 31 0x0 0x2>; /* PA31 gpio multidrive I2C0 clock */ > + }; > + }; > + > + i2c_gpio1 { > + pinctrl_i2c_gpio1: i2c_gpio1-0 { > + atmel,pins = > + <2 0 0x0 0x2 /* PC0 gpio multidrive I2C1 data */ > + 2 1 0x0 0x2>; /* PC1 gpio multidrive I2C1 clock */ > + }; > + }; > + > + i2c_gpio2 { > + pinctrl_i2c_gpio2: i2c_gpio2-0 { > + atmel,pins = > + <1 4 0x0 0x2 /* PB4 gpio multidrive I2C2 data */ > + 1 5 0x0 0x2>; /* PB5 gpio multidrive I2C2 clock */ > + }; > + }; > + > pioA: gpio at fffff400 { > compatible = "atmel,at91sam9x5-gpio", "atmel,at91rm9200-gpio"; > reg = <0xfffff400 0x200>; > @@ -583,6 +607,8 @@ > i2c-gpio,delay-us = <2>; /* ~100 kHz */ > #address-cells = <1>; > #size-cells = <0>; > + pinctrl-names = "default"; > + pinctrl-0 = <&pinctrl_i2c_gpio0>; > status = "disabled"; > }; > > @@ -596,6 +622,8 @@ > i2c-gpio,delay-us = <2>; /* ~100 kHz */ > #address-cells = <1>; > #size-cells = <0>; > + pinctrl-names = "default"; > + pinctrl-0 = <&pinctrl_i2c_gpio1>; > status = "disabled"; > }; > > @@ -609,6 +637,8 @@ > i2c-gpio,delay-us = <2>; /* ~100 kHz */ > #address-cells = <1>; > #size-cells = <0>; > + pinctrl-names = "default"; > + pinctrl-0 = <&pinctrl_i2c_gpio2>; > status = "disabled"; > }; > }; > -- > 1.7.2.5 > > > _______________________________________________ > linux-arm-kernel mailing list > linux-arm-kernel at lists.infradead.org > http://lists.infradead.org/mailman/listinfo/linux-arm-kernel