From: Wolfgang Denk Date: Fri, 15 Mar 2013 21:52:45 +0100 Subject: [U-Boot] [PATCH v4] Add initial support for Wandboard dual lite and solo. In-Reply-To: References: <1363228354-29534-1-git-send-email-festevam@gmail.com> <20130314123136.3A79E2005BB@gemini.denx.de> Message-ID: <20130315205245.207642005F7@gemini.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Dear Fabio Estevam, In message you wrote: > > >> +#define CONFIG_SYS_MEMTEST_START 0x10000000 > >> +#define CONFIG_SYS_MEMTEST_END 0x10010000 > > > > This makes no sense. Please see doc/README.memory-test > > This is something that always causes me confusion. > > doc/README.memory-test is not available in u-boot-imx. but I looked in > the archives. It's in master by now. > What is a good and safe value, I should use here? As explained, reasonable values for _START are just above the exception vectors - if any, and _END should be a bit below the space used for U-Boot's stack. I have to admit that I don't understand what the i.MX6 port is doing with the memory. Normally, a warmboot should not change it's content, yet here it does. Also I don't think there are exception vectors actually used in low memory, because when I erase all this memory the system still continues to run. Sorry, I'm afraid I'm not much of a help here. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de Never worry about theory as long as the machinery does what it's supposed to do. - R. A. Heinlein