From: u.kleine-koenig@pengutronix.de (Uwe =?iso-8859-1?Q?Kleine-K=F6nig?=) Date: Thu, 21 Mar 2013 10:15:31 +0100 Subject: [PATCH] clk: divider: Use DIV_ROUND_CLOSEST In-Reply-To: <20130320185051.GA28349@pengutronix.de> References: <2e77dfe8-8d4f-4b77-bf1b-831ad1572c23@VA3EHSMHS046.ehs.local> <20130320001609.8663.21043@quantum> <20130320185051.GA28349@pengutronix.de> Message-ID: <20130321091531.GN20530@pengutronix.de> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hello, On Wed, Mar 20, 2013 at 07:50:51PM +0100, Sascha Hauer wrote: > On Wed, Mar 20, 2013 at 09:32:51AM -0700, S?ren Brinkmann wrote: > > If the caller > > doesn't like the returned frequency he can request a different one. > > And he's eventually happy with the return value he calls > > clk_set_rate() requesting the frequency clk_round_rate() returned. > > Always rounding down seems a bit odd to me. > > > > Another issue with the current implmentation: > > clk_divider_round_rate() calls clk_divider_bestdiv(), which uses the ROUND_UP macro, returning a rather low frequency. > > And that is correct. clk_divider_bestdiv is used to calculate the > maximum parent frequency for which a given divider value does not > exceed the desired rate. The reason for that is that the (more?) usual constraint is like: This mmc card can handle up to 100 MHz. Or this i2c device can handle up to this and that frequency. Of course there are different constraints, e.g. for a UART if the target baud speed is 38400 you better run at 38402 than at 19201. I wonder if it depends on the clock if you want "best approximation <= requested value" or "best approximation" or on the caller. In the former case a flag for the clock would be the right thing (as suggested in this thread). If however it's the caller of round_rate who knows better which rounding is preferred than better extend the clk API. Extending the API could just be a convenience function that doesn't affect the implementations of the clk API. E.g.: long clk_round_rate_nearest(struct clk *clk, unsigned long rate) { long lower_limit = clk_round_rate(clk, rate); long upper_limit = clk_round_rate(clk, rate + (rate - lower_limit)); if (rate - lower_limit < upper_limit - rate) return lower_limit; else return upper_limit; } Best regards Uwe -- Pengutronix e.K. | Uwe Kleine-K?nig | Industrial Linux Solutions | http://www.pengutronix.de/ |