From: Wolfgang Denk Date: Fri, 22 Mar 2013 21:57:13 +0100 Subject: [U-Boot] [PATCH 14/21] powerpc/b4860qds: Assign DDR address in board file In-Reply-To: <1363973052-25918-12-git-send-email-yorksun@freescale.com> References: <1363973052-25918-1-git-send-email-yorksun@freescale.com> <1363973052-25918-12-git-send-email-yorksun@freescale.com> Message-ID: <20130322205713.2F8322014CE@gemini.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Dear York Sun, In message <1363973052-25918-12-git-send-email-yorksun@freescale.com> you wrote: > B4860QDS requires DDRC2 has 0 as base address and DDRC1 has higher address. > This is the requirement for DSP cores to run in 32-bit address space. > > Signed-off-by: York Sun > --- > board/freescale/b4860qds/ddr.c | 72 ++++++++++++++++++++++++++++++++++++++++ > 1 file changed, 72 insertions(+) CHECK: Alignment should match open parenthesis #151: FILE: board/freescale/b4860qds/ddr.c:213: + debug("rank density is 0x%llx, ctlr density is 0x%llx\n", + rank_density, ctlr_density); WARNING: line over 80 characters #153: FILE: board/freescale/b4860qds/ddr.c:215: + switch (pinfo->memctl_opts[i].memctl_interleaving_mode) { CHECK: Alignment should match open parenthesis #187: FILE: board/freescale/b4860qds/ddr.c:249: + debug("ctrl %d dimm %d base 0x%llx\n", + i, j, current_mem_base); Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de Work 8 hours, sleep 8 hours; but not the same 8 hours.