From: andrew@lunn.ch (Andrew Lunn) Date: Mon, 25 Mar 2013 10:30:01 +0100 Subject: [PATCH v2 00/14] Marvell EBU thermal sensor consolidation In-Reply-To: <1363991114-4225-1-git-send-email-ezequiel.garcia@free-electrons.com> References: <1363991114-4225-1-git-send-email-ezequiel.garcia@free-electrons.com> Message-ID: <20130325093001.GH5627@lunn.ch> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Fri, Mar 22, 2013 at 07:25:00PM -0300, Ezequiel Garcia wrote: > Given Armada 370/XP and the other Marvell SoC with thermal support, > namely Kirkwood and Dove, have fairly similar thermal devices it > makes sense to integrate all of them into a single driver: mvebu-thermal. Hi Ezequiel I'm still not convinced that one driver is the right way to go. As you have recently seen, Dove needs its own get_value() function, adding yet more differences. There is still the open question about 370 "managed" temperature, do that also need exporting? Lets also try to look into the crystal ball about what may happen next. There is an out of tree Dove driver https://github.com/rabeeh/linux-2.6.32.9/blob/master/arch/arm/mach-dove/hwmon.c This shows that the same register space is also used for core and CPU voltage measurements. At some point it might be nice to add support for these, and it probably needs to be in this driver, otherwise the locking is not nice. That driver also adds basic thermal management, by scaling the CPU frequency. Most of the scaling code will go into a driver in drivers/cpu_freq, but i guess there needs to be some glue somewhere? 370 seems to have some thermal management hardware. There are registers called Thermal Manager Control and Status Register, Thermal Manager Cooling Delay Register, Thermal Manager Overheat Delay Register. I've no idea what they do, if they are setup once and forgotten, or if there needs to be active monitoring etc? Maybe we will want to again link to cpu_freq? Will this need 370 specific glue code? I assume XP also have some thermal management system, since this is a server class CPU. More glue to cpu_freq, again specific to XP? Maybe the 370 and XP require the same glue? Orion and Kirkwood are simple, in that i've never seen any thermal management, other than a fan for the whole box, often controlled by a PIC, sometimes by GPIO lines. What does all this mean? I _think_ there will be less and less shared code in future as these extra features are added. I've not a strong opinion, but i think separate drivers are better. If we do stick to one driver, i would however want #ifdef CONFIG_ARCH_DOVE, CONFIG_ARCH_KIRKWOOD, CONFIG_MACH_ARMADA_XP & CONFIG_MACH_ARMADA_370 scattered through the code. Andrew