From: marex@denx.de (Marek Vasut) Date: Tue, 2 Apr 2013 01:37:38 +0200 Subject: [PATCH 4/5] spi/mxs: Remove bogus setting of ssp clk rate field In-Reply-To: References: <1364570381-17605-1-git-send-email-tpiepho@gmail.com> <201304020116.04781.marex@denx.de> Message-ID: <201304020137.39154.marex@denx.de> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Dear Trent Piepho, > On Mon, Apr 1, 2013 at 4:16 PM, Marek Vasut wrote: > >> The ssp struct has a clock rate field, to provide the actual value, in > >> Hz, of the SSP output clock (the rate of SSP_SCK) after > >> mxs_ssp_set_clk_rate() is called. It should be read-only, except for > >> mxs_ssp_set_clk_rate(). > >> > >> For some reason the spi-mxs driver decides to write to this field on > >> init, and sets it to the value of the SSP input clock (clk_sspN, from > >> the MXS clocking block) in kHz. It shouldn't be setting the value, and > >> certainly shouldn't be setting it with the wrong clock in the wrong > >> units. > > > > I suspect this patch should also fix drivers/clk/mxs/clk-ssp.c then? > > Why do you say that? I see no problem with clk-ssp.c, as setting the > clk_rate field in the ssp struct to the actual programmed rate makes > sense. The code in spi-mxs.c just makes no sense. I suspect it was > added by mistake when porting the driver. Either remove it altogether if it's unused OR make sure it's inited to some sane value from the start. Best regards, Marek Vasut