From: linux@arm.linux.org.uk (Russell King - ARM Linux) Date: Thu, 16 May 2013 17:39:16 +0100 Subject: [RFC] ARM: Allow user selection HZ values Message-ID: <20130516163916.GU18614@n2100.arm.linux.org.uk> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Allow users to configure the Hz rate on implementations which do not have a fixed clock rate. Signed-off-by: Russell King --- Whenever HZ_FIXED is not set through one of its "default" settings, the user is allowed to select a tick rate from 100, 200, 250, 300, 500Hz and 1kHz. This is slightly more choice than with the generic HZ selection in kernel/Kconfig.hz (which only does 100, 250, 300Hz and 1kHz). The reason for including 200Hz is that a greater number of other platforms want that via the fixed rate, and 500Hz just seemed to be a better middle value than 300Hz (which is of course stupidly close to 250.) arch/arm/Kconfig | 40 ++++++++++++++++++++++++++++++++++++++-- 1 files changed, 38 insertions(+), 2 deletions(-) diff --git a/arch/arm/Kconfig b/arch/arm/Kconfig index 67874b8..dcd16ff 100644 --- a/arch/arm/Kconfig +++ b/arch/arm/Kconfig @@ -1646,14 +1646,50 @@ config ARCH_NR_GPIO source kernel/Kconfig.preempt -config HZ +config HZ_FIXED int default 200 if ARCH_EBSA110 || ARCH_S3C24XX || ARCH_S5P64X0 || \ ARCH_S5PV210 || ARCH_EXYNOS4 default OMAP_32K_TIMER_HZ if ARCH_OMAP && OMAP_32K_TIMER default AT91_TIMER_HZ if ARCH_AT91 default SHMOBILE_TIMER_HZ if ARCH_SHMOBILE - default 100 + +choice + depends on !HZ_FIXED + prompt "Timer frequency" + +config HZ_100 + bool "100 Hz" + +config HZ_200 + bool "200 Hz" + +config HZ_250 + bool "250 Hz" + +config HZ_300 + bool "300 Hz" + +config HZ_500 + bool "500 Hz" + +config HZ_1000 + bool "1000 Hz" + +endchoice + +config HZ + int + default HZ_FIXED if HZ_FIXED + default 100 if HZ_100 + default 200 if HZ_200 + default 250 if HZ_250 + default 300 if HZ_300 + default 500 if HZ_500 + default 1000 + +config SCHED_HRTICK + def_bool HIGH_RES_TIMERS config THUMB2_KERNEL bool "Compile the kernel in Thumb-2 mode" -- 1.7.4.4