From: marex@denx.de (Marek Vasut)
Date: Fri, 23 Aug 2013 01:58:05 +0200
Subject: [PATCH V1 3/5] mtd: m25p80: add the quad-read support
In-Reply-To: <20130822233611.GA25263@sirena.org.uk>
References: <1376885403-12156-1-git-send-email-b32955@freescale.com>
 <201308222229.01778.marex@denx.de> <20130822233611.GA25263@sirena.org.uk>
Message-ID: <201308230158.05909.marex@denx.de>
To: linux-arm-kernel@lists.infradead.org
List-Id: linux-arm-kernel.lists.infradead.org

Dear Mark Brown,

> On Thu, Aug 22, 2013 at 10:29:01PM +0200, Marek Vasut wrote:
> > > On Thu, Aug 22, 2013 at 12:34:53PM -0700, Brian Norris wrote:
> > > 
> > > This should be a generic property for all quad devices to use, though,
> > > since the same thing applies everywhere.
> > 
> > Full ACK, "m25p,dual-read" and "m25p,quad-read" sound like a good prop
> > names?
> 
> I was actually thinking something more generic than that - putting the
> property at the SPI generic bindings level.  Though if all flashes with
> this dual/quad read functionality have the prefix m25p the above would
> work also, at the minute this does seem to be mostly used by flash (I
> bet someone's got some DSPs or something though).

Ah! So you mean the SPI controller would provide information that it can do 
dual/quad transfers? But then, the additional pins can only be wired to certain 
chips (controller by certain CS lines).

Best regards,
Marek Vasut