From: marex@denx.de (Marek Vasut) Date: Sun, 6 Oct 2013 15:54:50 +0200 Subject: [PATCH 2/3 V4] i2c: mxs: Rework the PIO mode operation In-Reply-To: <20131006135135.GB4173@katana> References: <20131004052052.GA3194@katana> <1381060933-11111-1-git-send-email-marex@denx.de> <20131006135135.GB4173@katana> Message-ID: <201310061554.50583.marex@denx.de> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi Wolfram, > On Sun, Oct 06, 2013 at 02:02:13PM +0200, Marek Vasut wrote: > > Analyze and rework the PIO mode operation. The PIO mode operation > > was unreliable on MX28, by analyzing the bus with LA, the checks > > for when data were available or were to be sent were wrong. > > > > The PIO WRITE has to be completely reworked as it multiple problems. > > The MX23 datasheet helped here, see comments in the code for details. > > The problems boil down to: > > - RUN bit in CTRL0 must be set after DATA register was written > > - The PIO transfer must be 4 bytes long tops, otherwise use > > > > clock stretching. > > > > Both of these fixes are implemented. > > > > The PIO READ operation can only be done for up to four bytes as > > we are unable to read out the data from the DATA register fast > > enough. > > > > This patch also tries to document the investigation within the > > code. > > > > Signed-off-by: Marek Vasut > > Applied the series to for-next, thanks! > > > (and fixed my local pre-commit hook) > > Yay :) Thanks! It was quite a lengthy gig here ;-) Best regards, Marek Vasut