From: Tom Rini Date: Mon, 4 Nov 2013 09:18:31 -0500 Subject: [U-Boot] TI:armv7: Change CONFIG_SYS_SPL_ARGS_ADDR to a higher address In-Reply-To: <1380898300-15059-1-git-send-email-trini@ti.com> References: <1380898300-15059-1-git-send-email-trini@ti.com> Message-ID: <20131104141831.GS5925@bill-the-cat> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Fri, Oct 04, 2013 at 10:51:40AM -0400, Tom Rini wrote: > With changes to increase the size of the device tree (required to move > more data out of the kernel and into DT), loading the args at the old > address leads to us overwriting things later on. To correct this, load > the args file to where we load the device tree anyhow. This is also > safe for non-DT booting as in either case we use r2 to pass in the > location of things. > > Signed-off-by: Tom Rini Applied to u-boot-ti/master, thanks! -- Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: not available Type: application/pgp-signature Size: 836 bytes Desc: Digital signature URL: