From: Tom Rini Date: Mon, 4 Nov 2013 09:18:37 -0500 Subject: [U-Boot] dra7xx_evm: Enabled UART-boot mode and add dra7xx_evm_uart3 build In-Reply-To: <1380912722-20390-1-git-send-email-trini@ti.com> References: <1380912722-20390-1-git-send-email-trini@ti.com> Message-ID: <20131104141837.GT5925@bill-the-cat> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Fri, Oct 04, 2013 at 02:52:02PM -0400, Tom Rini wrote: > From: Minal Shah > > UART booting is supported on this SoC, but via UART3 rather than UART1. > Because of this we must change the board to use UART3 for all console > access (only one UART is exposed on this board and a slight HW mod is > required to switch UARTs). > > Signed-off-by: Minal Shah > [trini: Make apply to mainline, reword commit] > Signed-off-by: Tom Rini Applied to u-boot-ti/master, thanks! -- Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: not available Type: application/pgp-signature Size: 836 bytes Desc: Digital signature URL: