From: Tom Rini Date: Tue, 12 Nov 2013 10:04:05 -0500 Subject: [U-Boot] [U-Boot, v3, 5/5] arm, am335x: update for the siemens boards In-Reply-To: <1383570303-26750-6-git-send-email-hs@denx.de> References: <1383570303-26750-6-git-send-email-hs@denx.de> Message-ID: <20131112150405.GU420@bill-the-cat> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Mon, Nov 04, 2013 at 02:05:03PM +0100, Heiko Schocher wrote: > From: Samuel Egli > > - dxr2: define unused pins as input > - do not enable RTC32K OSC on dxr2 board > - update default environment > - add splashpos=m,m to default environment, so splash screen is always > centered. > - adapt environment for bootcount feature > - add altbootcmd to default environment > - rut: SPL add early reset pulse for eth-phy, maXTouch and display > - rut: display timing aenderungen > - siemens boards: adapt for background color = white > - add boutcount feature for the siemens boards > store the bootcount in the environment, as we have no softreset > save registers on this hardware. Use therefore the CONFIG_BOOTCOUNT_ENV > bootcount driver. > - change spi mode from 3 to 0 for the lcd init > - add gpio pin for lcd reset with state 0 and add mdelay > - siemens boards: use own USB id's > - add dfu serial and device number for siemens boards > Add for the siemens boards the possibility to define in dfu mode, > the iSerialNumber and the bcdDevice fields in the USB Device > descriptor. > - fix upgrade mechanism based on bootcount > Correct location of saveenv and remove not active variable. > > Add CONFIG_BOOT_RETRY_TIME and CONFIG_RESET_TO_RETRY to > reboot board in case of empty kernel partition. Without > these defines an empty kernel partition leads to an > abort of boot process and one remains in u-boot prompt. > > - general cleanup of dxr2, pxm2 and rut boards > all: > * Remove net boot from bootcmd > Ping can cause a crash on boards without ethernet phy. > net_nfs command is used only for development > > * Add reset at the end of bootcmd > In order to have an immediate reset of the boot when bootcmd > fails, add reset at the end of bootcmd. > > rut: > * add nand_img_size > > dxr2: > * update nand_img_size > > * ddr3 timings updated with iocontrol property that can be > modified via eeprom. New default parameters from software > leveling with draco ES2. > > Signed-off-by: Samuel Egli > Signed-off-by: Pascal Bach > Signed-off-by: Roger Meier > Signed-off-by: Heiko Schocher > Cc: Matthias Michel > Cc: Tom Rini Applied to u-boot/master, thanks! -- Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: not available Type: application/pgp-signature Size: 836 bytes Desc: Digital signature URL: