From: horms@verge.net.au (Simon Horman) Date: Thu, 21 Nov 2013 13:04:18 +0900 Subject: [PATCH] ARM: shmobile: Configure r8a7791 PFC on Koelsch via DTS In-Reply-To: <20131120073659.22718.79556.sendpatchset@w520> References: <20131120073659.22718.79556.sendpatchset@w520> Message-ID: <20131121040416.GH31130@verge.net.au> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Wed, Nov 20, 2013 at 04:36:59PM +0900, Magnus Damm wrote: > From: Magnus Damm > > Configure the "D" set of data signals for SCIF0 and SCIF1 > on the Koelsch board to setup pinctrl serial console bits. > Signed-off-by: Magnus Damm Thanks, I will queue this up after removing the trailing blank line that this patch introduces. Assuming all goes will I plan to push this and other updates today or tomorrow. > --- > > arch/arm/boot/dts/r8a7791-koelsch-reference.dts | 16 ++++++++++++++++ > 1 file changed, 16 insertions(+) > > --- 0001/arch/arm/boot/dts/r8a7791-koelsch-reference.dts > +++ work/arch/arm/boot/dts/r8a7791-koelsch-reference.dts 2013-11-20 16:23:06.000000000 +0900 > @@ -30,3 +30,19 @@ > #size-cells = <1>; > }; > }; > + > +&pfc { > + pinctrl-0 = <&scif0_pins &scif1_pins>; > + pinctrl-names = "default"; > + > + scif0_pins: serial0 { > + renesas,groups = "scif0_data_d"; > + renesas,function = "scif0"; > + }; > + > + scif1_pins: serial1 { > + renesas,groups = "scif1_data_d"; > + renesas,function = "scif1"; > + }; > +}; > + >