From: peter.chen@freescale.com (Peter Chen) Date: Sun, 24 Nov 2013 18:12:06 +0800 Subject: [PATCHv2] usb: chipidea: add support for USB OTG controller on TI-NSPIRE In-Reply-To: <1385278667-91856-1-git-send-email-dt.tangr@gmail.com> References: <1385278667-91856-1-git-send-email-dt.tangr@gmail.com> Message-ID: <20131124101205.GA30724@shlinux1.ap.freescale.net> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Sun, Nov 24, 2013 at 06:37:47PM +1100, dt.tangr at gmail.com wrote: > From: Daniel Tang > > Changelog v2: > * Rename ci13xxx to ci_hdrc > * Fixed alignment issues > > The USB controller in TI-NSPIRE calculators are based off either Freescale's > USB OTG controller or the USB controller found in the IMX233, both of which > are Chipidea compatible. > > This patch adds a device tree binding for the controller. > > Signed-off-by: Daniel Tang > --- Please put the "Changelog v2" here, the change log should not be in commit log, it is for review purpose. > +}; > + > +MODULE_DEVICE_TABLE(of, ci_hdrc_nspire_dt_ids); > +module_platform_driver(ci_hdrc_nspire_driver); > + > +MODULE_ALIAS("platform:nspire_usb"); > +MODULE_ALIAS("platform:ci_hdrc_nspire"); Just curious, why you need to two alias? -- Best Regards, Peter Chen