From: marex@denx.de (Marek Vasut) Date: Tue, 26 Nov 2013 21:46:09 +0100 Subject: [PATCH RFC] PCI: imx6: remove outbound io/mem ATU region mapping In-Reply-To: <20131023064051.GA7646@pratyush-vbox> References: <1382504143-27915-1-git-send-email-tharvey@gateworks.com> <20131023064051.GA7646@pratyush-vbox> Message-ID: <201311262146.09780.marex@denx.de> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Dear Pratyush Anand, > Hi, > > On Wed, Oct 23, 2013 at 12:55:43PM +0800, Tim Harvey wrote: > > The IMX6 iATU is used for address translation between the AXI bus > > address space and PCI address space. This is used for type0 and type1 > > config cycles but is not necessary for outbound io/mem regions. > > > > This patch removes the calls that inappropriately re-configures the ATU > > viewport for outbound memory and IO after config cycles and removes them > > altogether as they are not necessary. > > > > This resolves issues with PCI devices behind switches and has been tested > > with a Gige device behind a PLX PEX860x switch. More testing is needed > > for other configurations. > > It seems to me that in your controller you have only one view port. > Also mem_base and mem_bus_addr is same. Thats why it works in your > case. MX6 has 4 In/4 Out viewports AFAICT. Best regards, Marek Vasut