From: Thomas Petazzoni Date: Wed, 27 Nov 2013 16:28:39 +0100 Subject: [U-Boot] OMAP3 i2c issues on IGEP, u-boot 2013.10 In-Reply-To: <52960748.4020203@compulab.co.il> References: <20131127131929.34505e23@skate> <20131127151121.51f124e6@skate> <52960748.4020203@compulab.co.il> Message-ID: <20131127162839.0b7f65c3@skate> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Dear Nikita Kiryanov, On Wed, 27 Nov 2013 16:52:56 +0200, Nikita Kiryanov wrote: > >> Not sure to understand your question: my paragraph above mentions the > >> IGEP board as being the platform on which I'm seeing this. So indeed, a > >> OMAP3-based board is affected. But maybe I misunderstood your question. > >> > > > > Oops, sorry, bad question :) > > > > Anybody knows if other OMAP3-based boards are affected for this issue ? > > Our boards were also affected by this, and I managed to track the > problem down to the zeroing of cnt register at the end of write, which > was not present in the original version of the driver and appears to be > triggering an issue that is mentioned in OMAP3 errata. > > I just posted a patch to address this problem. You can find it here: > http://patchwork.ozlabs.org/patch/294593/ Thanks for this patch. Unfortunately, I've applied it, and it doesn't fix the problem for me. I still have those I2C issues (did 3 boots of the IGEP boards, two of the boot failed with an endless stream of "i2c_read (addr phase): pads on bus 0 probably not configured (status=0x10)") message. Thanks, Thomas -- Thomas Petazzoni, CTO, Free Electrons Embedded Linux, Kernel and Android engineering http://free-electrons.com