From: jason@lakedaemon.net (Jason Cooper) Date: Sun, 1 Dec 2013 17:21:17 -0500 Subject: [PATCHv0] ARM: kirkwood: Add support for NETGEAR ReadyNAS NV+ v2 In-Reply-To: <58e99356aad0daf90d28162eac6a4ecec70470f8.1385822676.git.arno@natisbad.org> References: <58e99356aad0daf90d28162eac6a4ecec70470f8.1385822676.git.arno@natisbad.org> Message-ID: <20131201222117.GD2879@titan.lakedaemon.net> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Sat, Nov 30, 2013 at 04:13:44PM +0100, Arnaud Ebalard wrote: > > Almost all hardware parts of the NETGEAR ReadyNAS NV+ v2 ([1] for more > details) are supported by mainline kernel. The only missing elements in > provided .dts file are: > > - the front LCD module (Winstar WINSTAR WH1602): driver development is > ongoing. This is the same LCD module as on ReadyNAS 104. > - the Macronix MX25L512 512Kbit SPI flash: no time to play with it yet. > > The device is the big brother (4 vs 2 bay) of the ReadyNAS Duo v2. The > main differences are some additional LEDs for the disks, a Marvell > 88SM4140 SATA Port multiplier (no driver required to access the disk) > and previously described LCD module. Otherwise, it shares the same SoC > (kirkwood 88F6282), RAM (256MB), NAND (128MB), RTC chip (Ricoh rs5c372a), > fan controller (GMT G762), XHCI controller (NEC/Renesas ?PD720200). > > [1]: http://natisbad.org/NAS5/ > > Signed-off-by: Arnaud Ebalard > --- ... > > arch/arm/boot/dts/Makefile | 1 + > .../boot/dts/kirkwood-netgear_readynas_nv+_v2.dts | 270 +++++++++++++++++++++ > 2 files changed, 271 insertions(+) > create mode 100644 arch/arm/boot/dts/kirkwood-netgear_readynas_nv+_v2.dts Applied to mvebu/dt thx, Jason.