From: jason@lakedaemon.net (Jason Cooper) Date: Wed, 4 Dec 2013 09:33:17 -0500 Subject: [PATCH v4 1/4] cpufreq: Add a cpufreq driver for Marvell Dove In-Reply-To: <1386166641-7567-2-git-send-email-andrew@lunn.ch> References: <1386166641-7567-1-git-send-email-andrew@lunn.ch> <1386166641-7567-2-git-send-email-andrew@lunn.ch> Message-ID: <20131204143317.GL29282@titan.lakedaemon.net> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Wed, Dec 04, 2013 at 03:17:18PM +0100, Andrew Lunn wrote: > The Marvell Dove SoC can run the CPU at two frequencies. The high > frequencey is from a PLL, while the lower is the same as the DDR > clock. Add a cpufreq driver to swap between these frequences. > > Signed-off-by: Andrew Lunn > Tested-by: Sebastian Hesselbarth > Acked-by: Viresh Kumar > --- > Sort header files > Remove unneeded header files > Notify only on change > Use get_cpu_device(0), devm_clk_get() > Use platform_get_resource_byname() > Error check clk_prepare_enable() > Comment the interrupt handler > > rebase onto 3.13-rc2 linux-next Is there something you need that prevents you from basing on v3.13-rc1? > use target_index > --- > drivers/cpufreq/Kconfig.arm | 5 + > drivers/cpufreq/Makefile | 1 + > drivers/cpufreq/dove-cpufreq.c | 259 +++++++++++++++++++++++++++++++++++++++++ > 3 files changed, 265 insertions(+) > create mode 100644 drivers/cpufreq/dove-cpufreq.c Other than that, Acked-by: Jason Cooper thx, Jason.